Industrial Computer Peripherals
MIB20 AUTOMATIC BARRIER GATE
MIB20 Automatic Barrier GateTechnical Aspect
The combination of our proven and reliable electric motor with a lever system represents a simple and extremely reliable drive solution. It permits short opening and closing times without the barrier arm bouncing in the end positions. The lever system locks the barrier arm at both end positions. In the event of a power failure, it can still be moved easily by hand.
The completely driven system is attached to the barrier housing as a single unit, and can be easily removed from the housing, removing the mounting screws.
It is also a simple matter to change the handing on-site from right-axial to left-axial.
Drive Unit
The barrier is driven by a torque motor mounted on a central cast aluminum support. This support also contains the bearings for the drive shaft, the gear box and the mounting for the counterbalance springs.
The torque motor is designed for alternating current. It does not require limit switch or friction clutch, hence it is maintenance-free and can be stored in any position without the risk of damage. In the end positions, the motor remains under power assisting the mechanical locking of the barrier arm via the lever system. This reduces the power consumption to the minimum. This power is dissipated in the form of heat, which prevents the occurrence of condensation and corrosion. This guarantees reliable and problem-free operation.
The built-in position sensor provides precise barrier arm status information to the associated controller. The self learning control unit guarantees optimum braking without the barrier arm bouncing or swinging out of the end position. The barrier is factory wired, tested, ready to connect and supplied with all necessary mounting accessories.
Housing
The housing is manufactured from 2mm zinc plated sheet steel onto a base frame of stainless steel, then phosphate and powder coat finished for maximum protection against corrosion.
Control units are mounted onto a removable zinc plated sheet steel panel. All of the components within the barrier housing are readily accessible through the maintenance door and removable top cover. The housing is supplied in an RAL 2000 orange colour finish as standard.
Control Unit
The MLC controller was specially developed using microprocessor technology to ensure a flexible, modern approach to the control techniques. It possesses all appropriate expansion options including an I/O box and serial communication interface. The MLC and ancillary control units are fitted onto the fold-out mounting plate.
Barrier Arm
The barrier arm is extruded from highly stable aluminum alloy to produce an octagonal profile of 100mm X 55mm X 1.6mm and finished with RAL 9010 white powder coat, then applied with bright red reflective tapes strips, hence, the barrier arm is readily visible even at night.
Technical Specifications
Maximum arm length 3500 mm Opening and closing time 1.4 secs Voltage 230 / 115V Frequency 50 - 60 Hz Power consumption 120W Housing width 350 mm Depth 350 mm Height 1010 mm Weight not including barrier arm 50 kg
